Exit Stope Design

You can use this function to exit stope design.

When in Stope Design mode you cannot use Solids Repair, Ring Design, or End Planes. If you try to use those functions when in stope design mode, you are prompted to save your stope design.

Note: If you close the block model that you are using in stope design, you are prompted to exit stope design.

Prerequisites: You are in stope design mode. That is, you have run INIT STOPE.

To run this function: Choose Design > Stope Design tools > End Stope Designer, or...

• In the Function Chooser, type EXIT STOPE, and press ENTER.

Output

The .sdproj file is closed.