Display slope angle

You use this function to show the slope angle at each point on a selected segment. The slope angle you see depends on the method selected in the DESIGN SLOPE METHOD function.

To run this function: Choose Design > Pit design > Display slope angle, or...

• In the Function Chooser, type SHOW SLOPE ANGLE, and press ENTER.

When you run this function you see the following:

Select the segment to display the slope angle

Output

After selecting the segment the slope angle at each point on the selected segment is shown to the left of the points. The width value is displayed in the rubber band colour.

You can change the text, font, size, slant, and text path of the numeric values using the defaults.ssi file.