Display berm width

You use this function to show the berm width at each point on a selected segment. The berm width that you see depends on the method selected in the DESIGN SLOPE METHOD function.

To run this function: Choose Design > Pit design > Display berm width, or...

• In the Function Chooser, type SHOW BERM WIDTH, and press ENTER.

When you run this function you will see the following:

Select the segment to display the berm width

Select each segment you want to show berm widths.

Output

The berm width at each point on the selected segment is shown to the left of the points. The width value is displayed in the rubber band colour.

Note: You can change the text, font, size, slant, and text path of the numeric values using the defaults.ssi file.