Set length of one hole

To run this function: Choose Design > Ring design > Edit > Set length of one hole, or...

• In the Function Chooser, type SET LENGTH OF HOLE, and press ENTER.

Select the hole of interest 

Graphically select a hole at this prompt to display the HOLE LENGTH form.

Hole length

The new length of the hole.

Apply the form to give the hole the specified length and allow selection of another hole to edit or cancel the form to reselect the hole.

This function can be used to set the length of a single hole.

The specified hole length is greater than the maximum hole length of the rig

You have set the length of the hole to be further than the maximum hole length allowed by the current rig.