Rotate hole
To run this function: Choose Design > Ring design > Edit > Rotate hole, or...
Select the hole of interest
Select the hole you wish to move or choose Cancel to end the function. The mast will be rotated and moved to the position from which the selected hole was drilled. Any charge interval in the hole is removed. The mast, carousel and hole may now be rotated in the same manner described in ROTATE MAST By Graphics. The following prompt will be displayed:
Select and rotate the drill mast
Select a point on the mast or hole and drag the mast to rotate the mast and hole around the mast pivot point. Graphic feedback is provided to show the position of the mast and hole as it is rotated.
The Snap Hole function will extend or contract the rotated hole to the nearest stope intersection of the hole.
The New Rig position would be located outside the Survey Opening
Warning message displayed after selection of a hole to indicate that the mast cannot be moved to the selected hole and remain in the survey opening, or after rotation of the hole, to indicate that the mast would intersect the drive outline if the hole was rotated to the selected position.
The new rig position would place the pivot point outside the reach of the rig
Warning message indicating that the mast cannot be mast cannot be moved to the selected hole as the pivot would be below the minimum height, above the maximum height or outside the lateral limits specified for the rig.