Rotate mast by graphics
This function allows you to rotate the mast graphically.
To run this function: Choose Design > Ring design > Rotate mast > By graphics, or...
Select and rotate the drill mast
Select a point on the mast and rotate the mast to the new position. Graphic feedback is provided to show the position of the mast as it is rotated.
If the new mast location is still within the survey opening, the mast will move to the new location, otherwise it will remain where it is and a warning will be displayed in the message window.
The New Rig position would be located outside the Survey Opening
Warning message indicating that the mast cannot be rotated to the specified angle and remain in the survey opening.
This function will repeat, allowing you rotate the mast until Cancel is pressed.