Move mast to setup of existing hole
This function allows you to move the mast to the setup position from which the selected hole was drilled.
To run this function: Choose Design > Ring design > Move mast > To setup of existing hole, or...
Select the hole of interest
Select a hole to move the mast to the position from which the hole was drilled.
If the new mast location is still within the survey opening and the pivot point is within the specified limits, the mast will will be moved to the setup position from which the selected hole was drilled, otherwise it will remain where it is and a warning will be displayed in the message window.
The New Rig position would be located outside the Survey Opening
Warning message indicating that the mast cannot be moved to the specified coordinates and remain in the survey opening.
The new rig position would place the pivot point outside the reach of the rig
Warning message indicating that the mast cannot be moved to the specified coordinates as the pivot would be below the minimum height, above the maximum height or outside the lateral limits specified for the rig. To see these limits, choose MOVE MAST By Graphics.