Charge all holes
To run this function: Choose Design > Ring design > Charging > Charge all holes, or...
If a design area has already been selected, you will be prompted for the names of the current drive and stope outlines with the CURRENT POSITION INFORMATION form.
Stope
The name of the current stope outline.
Drive
The name of the current drive outline.
If no drive has been selected, or the CURRENT POSITION INFORMATION form was applied, the Charge All Holes function will display the prompt:
Select the first hole to be charged
Select the first hole to be charged. All the holes drilled from the drive of the selected hole into the stope of the selected hole will be charged in clockwise order around the drive starting with this hole. The method used for determining stemming and charge length is specified on the Charging Parameters form.
Warnings
This function requires an existing hole
If no holes have been drilled, no holes are available to be charged.
The calculated charge length for hole aaa is shorter than the specified minimum charge length.
The named hole has not been charged because the calculated charge length is shorter than the minimum specified on the Charging Parameters form.
The selected hole has already been charged
One of the holes in the ring already contained a charge segment.